How can I fix a pocket door in the bathroom? - sliding bathroom doors
The door to my bathroom there is a bag with sliding doors (on the opposite wall), appears to have come from the length and now I can open or close. You roll again (of course shared the wall) is. Suggestions?
Saturday, January 9, 2010
Sliding Bathroom Doors How Can I Fix A Pocket Door In The Bathroom?
Subscribe to:
Post Comments (Atom)
3 comments:
Unfortunately, there are no easy answers .. Dissemination must be cut, redo the door, carved and painted and re floated on the Elimination of gypsum. Depending on the size, it would be cheaper to the door where the hole then countersunkpast framed and hanging in the rule to remove a door .. some can be answered here is a simple solution, but in reality there is no .. I paintedd 37 years, all my other guys are in the construction industry and we had to do a few times ... Normally, we have proposed at the end in the design, as here .. Sorry ... But if you could accidentally break out again .. The same problem occurs again and again, if not stop a problem ... The rolls are made after a certain time ... and can be a pain ...
Push to remove the lower part of the upper door to door
slide the door to easy and you can switch back on track
Bathroom doors received that most abuse in any home
Sounds like it could be time to install a new running rails
If you do not raise the door and a turn, you have to take off the door to get the door. This will require the removal of a piece of the molding that head, and probably the door jamb of the door that goes from one side of the door frame. Remove the side where the rollers on the top of the door. Because you have the door open for the replacement from the rolls. This causes the rollers to tilt back so that you connect more roll in touch.
Once the door is properly installed, you can use the nut on the upper roller adjustment mechanism on the door if necessary. Then put the overthrow of the door, fill nail holes or screw mastic large gaps, and need to be deleted.
It's a real pain to do. But if you can not replace the door intact on the roller with the door jamb is the only way to do this.
Post a Comment